Instructions for working with slider design 1. Perform standard nail plate preparation: manicure, pedicure. 2. Choose a suitable design, cut the image to shape, adjust it to the width of the nail, keeping in mind that the slider should be slightly narrower (approximately 0.5-1mm, as the slider will need to be well sealed under the top coat). 3. Apply a base coat, cure in a lamp. Then apply 1-2 layers of white background gel polish, leaving a 1mm gap from the cuticle line and side walls, curing each layer. 4. Apply a thin layer of top coat, cure. 5. Place the slider on a napkin moistened with warm, slightly hot (not cold!) water for approximately 15-20 seconds. Bring it to the nail, and using the sliding method, slide the film from the paper backing by 1/3, pressing the film at the base of the cuticle, leaving a 0.5-1mm margin at the cuticle line, then remove the backing completely. Smooth the film, gently pulling it to avoid wrinkles. Carefully smooth the film, pushing out any remaining air and water with a soft cloth. Cure nails with the slider in a lamp. 6. Using a fine-grit file, gently remove the film from the free edge of the nail with top-to-bottom movements. Wipe the edge of the nail with a lint-free wipe soaked in degreaser. 7. Apply a top coat, thoroughly sealing the tips and edges of the film at the cuticle base and side walls in 2 layers, curing each layer of top coat in a lamp. Remove the sticky layer.